- ページ 10

スイッチ Cisco C3850-NM-4-1GのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco C3850-NM-4-1G 15 ページ。
Cisco C3850-NM-4-1G にも：インストール (17 ページ)

ページを印刷する

Installing and Removing Cisco Transceiver Modules

Caution

Step 2

Disconnect the cables from the pluggable transceiver module.

Step 3

Remove the pluggable transceiver module from the network module.

Step 4

Loosen the captive screws that hold the network module in place until it completely disengages from the

chassis.

Note

Step 5

Carefully slide the network module out of the slot.

Step 6

Install a replacement network module or a blank module in the slot.

Step 7

Place the module that you removed in an antistatic bag or other protective environment.

Installing and Removing Cisco Transceiver Modules

Installing a Cisco Pluggable Transceiver Module

Before you begin

You must have an installed network module to use the transceiver modules. See the switch release notes on

Cisco.com for the list of supported pluggable transceiver modules. Use only supported pluggable transceivers

on the switch. For the latest information about supported transceiver modules, refer to the

Modules Compatibility

For information about installing, removing, cabling, and troubleshooting pluggable transceiver modules, see

the module documentation that shipped with your device.

Observe these precautions:

Warning

Class 1 laser product. Statement 1008

• Do not remove the dust plugs from the pluggable transceiver modules or the rubber caps from the

• Removing and installing a pluggable transceiver module can shorten its useful life. Do not remove and

• To prevent ESD damage, follow your normal board and component handling procedures when connecting

Installing a Network Module

A module interface might become error-disabled when a network module with connected fiber-optic

cables is installed or removed. If an interface is error-disabled, you can reenable the interface by

using the shutdown and no shutdown interface configuration commands.

The C3850-NM-8-10G module is held secure in the switch by only one jackscrew. This screw also

helps to eject the module from its connector interface. Before the module can be removed completely,

the screw must be unscrewed all the way out. When removing the screw, a spring pushes the module

out when the screw is completely disengaged. Ensure that you hold the module securely until it is

completely removed.

Information.

fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the module ports

and cables from contamination and ambient light.

insert any module more often than is necessary.

cables to the switch and other devices.

Installing a Network Module

Cisco Transceiver