- ページ 10

スイッチ Cisco C9300L-48PF-4XのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco C9300L-48PF-4X 16 ページ。

Dynamic Assignment

When using DHCP, the DHCP server should be configured to assign a static IP address for each MAC address

belonging to a Meraki switch. Other features of the network, such as 802.1X authentication, may rely on the property

that the switches have static IP addresses.

Please make sure that the DHCP server used for providing a management IP address to the switch has an available

address pool that falls within the active VLAN range.

Static IPs can be assigned using the local status page on each switch. For more information on how to configure static

IP from the local status page refer to this documentation.

Static IP via DHCP Reservations

Instead of associating each Meraki switch individually to configure static IP addresses, an administrator can assign static

IP addresses on the upstream DHCP server. Through "DHCP reservations," IP addresses are "reserved" for the MAC

addresses of the Meraki switches. Please consult the documentation for the DHCP server to conﬁgure DHCP

reservations.

Check upstream VLAN configuration

Ensure the upstream switch/router port is configured properly and there is no VLAN mismatch.

Check STP configuration

Meraki-managed C9300 series switches run a single instance of MST out of the box. Please read

MS Best

Practices

prior to deployment.

NOTE: If you plan to deploy Meraki switches into an existing Catalyst network running PVST/PVST+/Rapid-PVST,

please refer to this document for

interoperability.

To migrate your existing Catalyst switches to MSTP, please see

Configuring Spanning Tree on Meraki MS Switches

for more information.

Device reboot/ reset precaution

After powering on the unit or a device reboot, the power LED goes through the following cycle -

1. Solid amber

2. Cycle through different colors

3. Solid white if dashboard connectivity is successful or, remain solid amber if dashboard connectivity is unsuccessful.