- ページ 14

スイッチ Cisco Catalyst 2960 SeriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Catalyst 2960 Series 25 ページ。 Compact switches
Cisco Catalyst 2960 Series にも：データシート (16 ページ), データシート (11 ページ), データシート (9 ページ), 製品情報 (3 ページ), 製品情報 (5 ページ), データシート (21 ページ), 仕様 (2 ページ), パンフレット＆スペック (10 ページ), データシート (15 ページ), データシート (28 ページ), パンフレット (17 ページ), インストレーション・マニュアル (27 ページ)

Rack-Mounting

Installation Warning Statements

Warning

Catalyst 2960 Switch Getting Started Guide

1-12

This section includes the basic installation warning statements. Translations of

these warning statements appear in the Regulatory Compliance and Safety

Information for the Catalyst 2960 Switch guide.

Only trained and qualified personnel should be allowed to install, replace, or

service this equipment. Statement 148

To prevent the switch from overheating, do not operate it in an area that

exceeds the maximum recommended ambient temperature of 113°F (45°C). To

prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around

the ventilation openings. Statement 17B

Installation of the equipment must comply with local and national electrical

codes. Statement 1074

To prevent bodily injury when mounting or servicing this unit in a rack, you must

take special precautions to ensure that the system remains stable. The

following guidelines are provided to ensure your safety:

This unit should be mounted at the bottom of the rack if it is the only unit in the

rack.

When mounting this unit in a partially filled rack, load the rack from the bottom

to the top with the heaviest component at the bottom of the rack.

If the rack is provided with stabilizing devices, install the stabilizers before

mounting or servicing the unit in the rack. Statement 1006

This equipment is intended to be grounded. Ensure that the host is connected to

earth ground during normal use. Statement 39

Chapter 1

Getting Started Guide

OL-9368-03