- ページ 4

調光器 FIBARO Dimmer 2のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。FIBARO Dimmer 2 14 ページ。

2021. 04. 16.

NOTE: It is not recommended to install different types of wall switches (momentary, toggle, etc.) in a 3-way connection.

4. After verifying correctness of connection switch on the mains voltage

5. Wait around 30s for the calibration process to end (see „Calibration" on page 15), light may blink during the process

6. After successful calibration the device will be turned off by default

7. Add the device to the Z-Wave network (see „Adding/removing the device" on page 11)

8. Turn off the mains voltage, then arrange the device and its antenna in a wall switch box

9. Close the wall switch box and turn on the mains voltage

Tips for arranging the antenna:

• Locate the antenna as far from metal elements as possible (connecting wires, bracket rings, etc.) in order to prevent interferences.

• Metal surfaces in the direct vicinity of the antenna (e.g. flush mounted metal boxes, metal door frames) may impair signal reception!

• Do not cut or shorten the antenna - its length is perfectly matched to the band in which the system operates.

NOTE: After switching on the mains voltage LED indicator will signal Z-Wave network inclusion state with a colour: GREEN - device added RED - device not

added RED/GREEN ALTERNATELY- Z-Wave error

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the

devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This

controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.

Inclusion

Press three times the B-button or key connected to the S1 terminal.

Exclusion

Press three times the B-button or key connected to the S1 terminal.

Product Usage

Momentary switch (after releasing the switch a spring automatically pushes back and disconnects the switch):

• Turning the light ON/OFF: change the position of switch no. 1. The Dimmer 2 will be activated always at previously set brightness level.

• Brightening/dimming the light: hold switch no. 1 down. When the switch is held down, the Dimmer 2 will always reach the extreme value of 1% or 99%.

• Turning the light ON completely: fast double-click switch no. 1. The Dimmer 2 will set the load at 99%.

Toggle switch (operates as a two-position switch, it has no spring that would set one position of the switch):

• Turning the light ON/OFF: toggle switch no. 1. The Dimmer 2 will be activated always at previously set brightness level.

• Turning the light ON completely: toggle twice switch no. 1. The Dimmer 2 will set the load at 99%.

Controlling the Dimmer 2 using a command: ALL ON/ALL OFF in non-secure mode:

The Dimmer 2 responds to commands ALL ON/ALL OFF that may be sent by the Z-Wave controller. ALL ON/ALL OFF commands are usually implemented in the

remote controllers using Z-wave protocol, and they are used to issue commands directed to the entire system.

By default, both commands ALL ON and ALL OFF are accepted. Settings may be changed by modifying the value of parameter 11 (see „Advanced parameters" ).

In this way the user may determine to which commands the device should respond.

Controlling the Dimmer 2 using the B-button:

https://manual.zwave.eu/backend/make.php?lang=en&sku=FIBEFGD-212

4/14