会議システム Crestron Mercury CCS-UC-1のPDF マニュアルよりをオンラインで閲覧またはダウンロードできます。Crestron Mercury CCS-UC-1 2 ページ。 Tabletop conference system
Crestron Mercury CCS-UC-1 にも： クイックスタート (2 ページ), クイック・スタート・マニュアル (9 ページ), マニュアルより (2 ページ)
ページを印刷する
DO
GUIDE
CCS-UC-1
Tabletop Conference System
DO
Install the Cable Retention Plate (Optional)
Install the cable retention plate as shown in the following diagram.
CAUTION:
When turning over the device, place the device on a soft surface to avoid damage to the unit.
Install cable
retention plate
here
DO
Connect the Device
Hardware Hookup
Make the necessary connections as called out in the following diagram. Connect power last.
Display device
via 20' (6.10 m) HDMI
®
cable and IR or serial control
(CCS-UC-1 AV KIT and CCS-UC-1 AV W/PS KIT only)
Ground
Corporate
network
AUX:
10BASE-T/100BASE-TX
Ethernet to SIP or AirMedia
®
router
or PoE+
N
L A
Cable retention
plate installed
Laptop
via included USB cable and 6' (1.83 m) and HDMI cable
(CCS-UC-1 AV KIT and CCS-UC-1 AV W/PS KIT only)
USB/ACC:
For future use
24 Vdc, 2.5 A
CCS-UCA-MIC Microphone pods
AC power pack
(sold separately)
(CCS-UC-1 W/PS and
Must connect AC power pack to CCS-UC-1
CCS-UC-1 AV W/PS KIT only)
CCS-CAM-USB-F-100
(CCS-UC-1 AV KIT and CCS-UC-1 AV W/PS KIT only)
DO
Check the Box
QUANTITY
PRODUCT
1
Cable, USB 2.0, A - micro B, 6' (1.83 m)
1
Cable, RJ-45 Male - RJ-45 Male, 12' (3.66 m)
1
Retention Plate, Cable
3
Tie Wrap
Items for CCS-UC-1 W/PS
1
Power Pack, PW-2420RU
Items for CCS-UC-1 AV KIT
1
Cable, HDMI, 20' (6.10 m)
1
Cable, USB 2.0, A Female - A, 15' (4.57 m)
1
Cable, HDMI, 6' (1.83 m), Thin
1
Camera, CCS-CAM-USB-F-100
1
IR Emitter Probe, STIRP
Items for CCS-UC-1 AV W/PS KIT
1
Cable, HDMI, 20' (6.10 m)
1
Cable, USB 2.0, A Female - A, 15' (4.57 m)
1
Cable, HDMI, 6' (1.83 m), Thin
1
Camera, CCS-CAM-USB-F-100
1
IR Emitter Probe, STIRP
1
Power Pack, PW-2420RU
CAUTION:
PoE-type networks connected to these ports are for intrabuilding use only and should not be connected to lines that run outside of the
building in which this product is located.
NOTE:
The device can receive power over PoE+ or the included power pack. A power pack must be connected to the device if CCS-UCA-MIC
microphone pods are to be used.
Secure the Cables to the Cable Retention Plate
CAUTION:
When turning over the device, place the device on a soft surface to avoid damage to the unit.
Use the included wire tie to secure all of the cables to the cable retention plate that was installed in "DO Install the Cable Retention Plate."
Route the USB and HDMI IN Cables
Press the USB and HDMI IN cables into the channels on the underside of the device as shown in the following diagram so that the connectors can be
routed to the front of the device.
Route 6' HDMI
cable here
100-240 V
50/60 Hz
input power
DO
Configure the Device
Use the device's web interface to configure the device. For details on configuring the device, refer to the CCS-UC-1 Supplemental Guide
(Doc. 7844) at www.crestron.com/manuals.
COLOR
Route USB
cable here
PART NUMBER
2047803
2033988
2047908
2047935
6500187
6503567
6508260
6508218
6506442
6500940
6503567
6508260
6508218
6506442
6500940
6500187