- ページ 16
電子レンジ Sharp AX1200S - 22" SuperSteam OvenのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp AX1200S - 22" SuperSteam Oven 43 ページ。 Supersteam oven
Sharp AX1200S - 22" SuperSteam Oven にも： 操作マニュアル (43 ページ), 取付説明書 (8 ページ), 仕様 (2 ページ)
ページを印刷する
I M P O R T A N T I N S T R U C T I O N S
SUPER STEAM CONVECTION & STEAM IN
AUTOMATIC AND MANUAL COOKING
Before cooking
1. Make sure the reservoir is filled with fresh cold tap water and is installed. (See page 13.)
2. Make sure the empty drip tray is installed. (See page 13.)
3. Place food in the oven unless preheating is needed. (Refer to each chart to check if preheating in required in
automatic operations.)
After Cooking
1. After the oven has cooled, remove and empty the reservoir, wipe oven cavity, remove and empty the drip tray.
2. Perform the Drain Water function at least once a day after using SuperSteam Convection or Steam mode.
3. Check that water is not dripping down before removing the drip tray, as a small amount of water drains into the drip
tray when the reservoir is removed.
DRAIN WATER FUNCTION
Perform the Drain Water function at least once a day after
using SuperSteam Convection or Steam mode. It takes
from 1 to 8 minutes.
Drain Water function is very useful to keep oven clean, to
prevent scale build up and the use of stale water. It causes
evaporation of the internal steam system.
P R O C E D U R E
1
Press Back/Info,
turn the Dial to
select DRAIN
WATER and press
Enter.
2
Make sure the reservoir is
removed and press START.
After the oven has cooled, remove and empty
3
the reservoir, wipe oven cavity, remove and
empty the drip tray.
NOTE:
The reservoir must be removed for the Drain Water
function. If the reservoir is not removed, Drain Water
function does not start.
DESCALE FUNCTION
White or gray grains, also called scale, may form in
the water circuit inside the oven during steam
generation, which could cause the oven to malfunction.
When DESCALING NECESSARY is shown in the
display, be sure to carry out Descale function
immediately. It takes about 1 hour.
SEC AX1200 O/M,P01-
14
P R O C E D U R E
Set the empty drain tank in baking tray
1
on upper level in the oven.
2
Citric acid, available at some drugstores, or
bottled lemon juice with no pulp are used for
descaling. Choose one and prepare the
descaling solution.
To use citric acid, dissolve 1 tablespoon of
citric acid crystals in 2
non-porous container. Stir well and pour into
the reservoir.
To use 100% bottled lemon juice, check that
there is absolutely no pulp in it. If there is pulp
or you are not sure, strain through a fine
strainer. Measure
juice and add it to 2
and pour into the reservoir.
Place the reservoir in the oven correctly and
push firmly into place.
3
Press Back/Info,
turn the Dial to
select DESCALE
and press Enter.
4
Do not place any food in the oven.
Press START to begin descaling.
When the oven stops with the audible signal, a
5
message will appear in the display.
Empty the drain tank and
replace. Remove reservoir and
refill with cold tap water up to
the MAX mark. Press START.
Rinsing will start.
When rinsing has ended and the oven has
6
cooled, remove and empty the drain tank,
remove and empty the reservoir, wipe oven
cavity, remove and empty the drip tray.
14
08.9.24, 0:06 PM
1
/
cups of water in a
4
1
/
cup of the strained lemon
3
1
/
cups of water. Stir well
4