- ページ 11

電子レンジ Sharp Carousel R-1512のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sharp Carousel R-1512 32 ページ。 Over the range microwave oven
Sharp Carousel R-1512 にも：パンフレット＆スペック (8 ページ), 取付説明書 (40 ページ), 取付説明書 (9 ページ), 調理マニュアル (40 ページ), マニュアル (40 ページ)

ページを印刷する

PROCEDURE

LETTER

3) To discharge high voltage capacitor, wait for 60 seconds.

4) Replace the key unit.

5) Reconnect all leads removed from components during testing.

6) Re-install the outer case (cabinet).

7) Reconnect the power supply cord after the outer case is installed.

8) Run the oven and check all functions.

2. Control Unit.

The following symptoms indicate a defective control unit. Before replacing the control unit, perform

the Key unit test (Procedure M) to determine if control unit is faulty.

2-1 In connection with pads.

a) When touching the pads, a certain group of pads do not produce a signal.

b) When touching the pads, no pads produce a signal.

2-2 In connection with indicators

a) At a certain digit, all or some segments do not light up.

b) At a certain digit, brightness is low.

c) Only one indicator does not light.

d) The corresponding segments of all digits do not light up; or they continue to light up.

e) Wrong figure appears.

f) A certain group of indicators do not light up.

g) The figure of all digits flicker.

2-3 Other possible problems caused by defective control unit.

a) Buzzer does not sound or continues to sound.

b) Clock does not operate properly.

c) Cooking is not possible.

When testing is completed,

1) Disconnect the power supply cord.

2) Open the door and block it open.

3) To discharge high voltage capacitor, wait for 60 seconds.

4) Reconnect all leads removed from components during testing.

5) Re-install the hood intake duct R.

6) Re-install the outer case (cabinet).

7) Reconnect the power supply cord after the outer case is installed.

8) Run the oven and check all functions.

KEY UNIT TEST

1. Disconnect the power supply cord.

2. Open the door and block it open.

3. To discharge high voltage capacitor, wait for 60 seconds.

4. Remove the control panel assembly.

5. If the display fails to clear when the STOP/CLEAR pad is depressed, first verify the flat ribbon cable

is making good contact, verify that the door sensing switch operates properly; that is the contacts are

closed when the door is closed and open when the door is open. If the door sensing switch is good,

disconnect the flat ribbon cable that connects the key unit to the control unit and make sure the door

sensing switch is closed (either close the door or short the door sensing switch connecter). Use the

Key unit matrix indicated on the control panel schematic and place a jumper wire between the pins

that correspond to the STOP/CLEAR pad making momentary contact. If the control unit responds by

clearing with a beep the key unit is faulty and must be replaced. If the control unit does not respond,

it is faulty and must be replaced. If a specific pad does not respond, the above method may be used

(after clearing the control unit) to determine if the control unit or key pad is at fault.

6. Reconnect all leads removed from components during testing.

7. Re-install the control panel assembly.

8. Reconnect the power supply cord.

9. Run the oven and check all functions.

TEST PROCEDURES

COMPONENT TEST

R-1512

R-1511