- ページ 17
電子レンジ Sharp Carousel R-210DのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sharp Carousel R-210D 36 ページ。 Microwave oven
Sharp Carousel R-210D にも： 操作マニュアルと調理マニュアル (10 ページ), 操作マニュアル (24 ページ)
ページを印刷する
LSI(IXA023DR)
The I/O signal of the LSI(IXA023DR) are detailed in the following table.
Pin No.
Signal
1
D3
2
D4
3
D5
4
D6
5
D7
IN/OUT
6
P20
7
P21
8
P22
9
RESET
10
CNVSS
11
XOUT
12
XIN
13
VSS
14
VDD
15
N.F
16
INT0
DESCRIPTION OF LSI
I/O
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD8, LD16 and LD24).
OUT
Signal to sound buzzer.
A: Tact switch touch sound.
B: Completion sound.
OUT
Oven lamp, turntable motor and fan motor driving signal(Square Waveform
: 50Hz).
To turn on and off shut-off relay
(RY1). The square waveform volt-
age is delivered to the relay (RY1)
driving circuit and relay(RY2) con-
trol circuit.
OUT
Magnetron high-voltage circuit driving signal.
To turn on and off the cook relay (RY2). In
100% power operation, the signals hold
"L" level during microwave cooking and
"H" level while not cooking. In other cook-
ing modes (70%, 50%, 30%, 10%) the
signal turns to "H" level and "L" level in
repetition according to the power level.
Terminal not used.
IN
Connected to 0V.
IN
Signal coming from touch tact switch.
When tact switch SW2 is touched, a signal will be input into P21. When tact switch
is not touched, the signal is held at "H" level.
IN
Signal coming from encoder.
When the encoder is turned, the contacts of encoder make pulse signals. And
pulse signals are input into P22.
IN
Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is applied. Temporarily
set to "L" level the moment power is applied, at this time the LSI is reset. Thereafter
set at "H" level.
IN
Reference voltage input terminal.
A reference voltage is applied to the A/D converter in the LSI. Connected to VC.
OUT
Internal clock oscillation frequency control output.
Output to control oscillation input of XOUT.
IN
Internal clock oscillation frequency input setting.
The internal clock frequency is set by inserting the ceramic filter oscillation circuit
with respect to XIN terminal.
IN
Power source voltage: -5V.
The power source voltage to drive the LSI is input to VSS terminal. Connected to
VC.
IN
Power source voltage: 0V.
The power source voltage to drive the LSI is input to VDD terminal.
IN
Connected to VSS terminal.
IN
Signal coming from encoder.
Signal similar to INT0. Pulse signals are input into INT0.
Description
A
B
15
0.12 sec
2.4 sec
H: GND
L: -5V
20 msec
During cooking
ON/OFF time ratio in Mi-
cro cooking
(a. 27second time base)
MICRO
ON
OFF
COOK
100%
27sec.
0sec.
70%
21sec.
6sec.
50%
15sec.
12sec.
30%
9sec.
18sec.
10%
5sec.
22sec.
R-210D
H
L