- ページ 5

電子レンジ Sharp Carousel R-90GCのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp Carousel R-90GC 32 ページ。 High speed oven
Sharp Carousel R-90GC にも：パンフレット＆スペック (8 ページ), パンフレット＆スペック (5 ページ), 操作マニュアル (36 ページ), 操作マニュアル (36 ページ)

ページを印刷する

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

Unpacking and Examining Your Oven

Remove:

1. all packing materials from inside the oven cav-

ity; however, DO NOT REMOVE THE

WAVEGUIDE COVER, which is located on the

Safety door latches

Waveguide cover

Door seals and sealing surfaces

Door hinges

the outside of the door.

Check the oven for any damage, such as mis-

aligned or bent door, damaged door seals and

sealing surfaces, broken or loose door hinges and

latches and dents inside the cavity or on the door.

If there is any damage, do not operate the oven

and contact your dealer or SHARP

G R O U N D I N G I N S T R U C T I O N S

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a

grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in

accordance with the National Electrical Code and local codes and ordinances. In the event of an electri-

cal short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric

current.

WARNING

– Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 240 volt 60 Hz, AC only, 15 amp. or more

protected electrical supply. It is recommended that a separate circuit serv-

ing only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must be plugged

into a wall receptacle that is properly installed and grounded.

Extension Cord

If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding

plug and a 3-slot receptacle that will accept the plug on the microwave oven. The marked rating of the

extension cord should be AC 240 volt, 15 amp. or more.

Be careful not to drape the cord over the countertop or table where it can be pulled on by children or

tripped over accidentally.

Notes: 1. If you have any questions about the grounding or electrical instructions, consult a qualified

electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal injury

resulting from failure to observe the correct electrical connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the

microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as

feasible or check position and signal of receiving antenna.

right cavity wall.

Read enclosures and

SAVE the Operation

Manual. Sharp High

Speed Convection

Microwave

Oven

Cookbook and Touch

Guide.

2. the feature sticker,

if there is one, from

AUTHORIZED SERVICER.

Choosing a Location for Your Oven

You will use your oven frequently so plan its lo-

cation for ease of use. The oven must be placed

on a countertop which is a minimum of 36 inches

from the floor. Allow at least 2 inches on the sides,

top and at the rear of the oven for air circulation.

Be sure to position oven so that the rear cannot

be touched inadvertently.

Built-in Kit

Your oven can be built into a cabinet or wall—not

near or above a heat source—using one of

Sharp's Built-in Kits, Model RK-90S30. If your

dealer does not stock the kit, order directly by

call-ing 1-800-642-2122 to have it sent to your

address.

The kit includes ducts and finish trim strips and

easy-to-follow instructions for installation as well

as the location of the power supply.

Receptacle Box Cover

3-Pronged plug

(6-15P)

3-Pronged, Receptacle

(6-15R)