- ページ 32

液晶テレビ Sharp Aquos LC-26GD7EのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp Aquos LC-26GD7E 42 ページ。 Lcd colour television

ページを印刷する

Operating additional equipment

Login and connect equipment

You have logged in and connected all connected equipment in the initial

start-up. If you want to connect other equipment or disconnect equip-

ment, call the connection wizard.

Call up the TV menu

Select "Connections"

Select "AV setup" and

call up with OK.

State what equipment you want to connect. The connection wizard then

shows you which sockets you should connect this equipment to. Then

connect the equipment to these sockets.

Connecting VCR/DVD recorders

In addition to the connection via the Euro-AV sockets you also have

to connect the antenna (only for terrestrial antenna or cable systems)

through the VCR/DVD recorder to the TV set. The antenna signal is then

available to the VCR/DVD recorder and the TV set.

Note: Use Euro AV cables with right-angled plugs as shown.

ENTREE

ANTENNE

EURO AV2

DECODER

AUDIO

SORTIE

OUT

AERIAL

SORTIE

EURO AV1

ANTENNE

AUDIO/

VIDEO

RF OUT

Search for and store the station of the video recorder (if no Euro AV

cable is available)

Switch on the test station on the VCR or insert a recorded tape and start

playback. In some video recorders the station must be switched on by

activating the modulator.

Then call the AV selection on the TV set with

the menu item "VIDEO" in the AV selection and call with OK.

To prevent "normal" TV stations being found in the search, pull out the

antenna plug from the antenna input of the VCR temporarily (the cable to

the antenna system).

If you cannot see the test station or playback from the cassette, the VCR

is transmitting on a different station. You then have to search for the

station or set it manually.

Call the "TV menu" with the MENU button.

Select "Setup" with

Select "Channels" with

and press OK.

Select "Manual tune" with

Enter station "E30" under the "Channel" item (UHF range, select in this

menu above if necessary).

Start search with the blue button.

If the station has been found, enter the name "VIDEO", conﬁ rm with

OK and save with the red button.

A list of the stored stations is displayed

Select AV here and overwrite this programme place with the red but-

ton.

10.

Hide the menu with the END button.

Reconnect the antenna plug back in.

If you now get interference because a TV station is transmitting on the

same channel as the VCR station, you have to change the transmitting

station on the VCR and repeat the steps 1 ... 10.

or with button 0. Select

and press OK.