- ページ 24

ステレオシステム Sharp CD-BA300のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp CD-BA300 32 ページ。 Cdba300 operation manual
Sharp CD-BA300 にも: クイックマニュアル (4 ページ)

Sharp CD-BA300 操作マニュアル

Recording from a CD (CDs)

24
Programmed Play (See page 19)
*BA300_P23_25
24
You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the CD button and load the desired disc.
4
Press one of the s s s s s 1 - s s s s s 3 buttons to select the disc to be re-
corded first.
5
Press the REC PAUSE I6
I6
I6
I6
I6
(I6
I6) button.
I6
I6
I6
Recording will be paused.
6
Press the 0/R
0/R (TAPE 2 0 0 0 0 0 )
0/R
0/R
0/R
button to start recording.
CD playback will start approximately 5 seconds after the tape starts.
Recording is started from the selected CD. When the playback of the last
disc is finished or the end of the tape is reached, the CD and the cassette will
stop automatically.
To perform programmed recording:
1. Program discs and tracks (page 19).
2. Press the REC PAUSE I6 (I6) button.
3. Press the 0/R (TAPE 2 0) button.
To stop recording:
Press the
(CD ) button.
The CD and tape will stop.
Note:
When the end of the tape is reached while recording, the CD player will display the
track number which was being played at that time, and stop automatically.
If you want to restart recording from the interrupted track, turn over the tape, press the
REC PAUSE I6 (I6) button and then the 0/R (TAPE 2 0) button.
(If tracks have been stored in memory using the programmed recording, recording will
restart from the first track stored in memory.)
00.11.16, 2:53 PM