- ページ 12
ステレオシステム Sharp CD-DP2500HのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp CD-DP2500H 37 ページ。 Mini component system
ページを印刷する
SETTING THE CLOCK
(Main unit operation)
Downloaded from:
http://www.usersmanualguide.com/
In this example, the clock is set for the 24-hour (0:00) system.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.
4
Press the TUNING/TIME (X or W) button to select the time
display mode.
→The 24-hour display will appear.
"0:00"
(0:00 - 23:59)
"AM 0:00" →The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00" →The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first in-
stalled or it has been reset (see page 32).
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME (X or W) button to adjust the hour.
Press the TUNING/TIME (X or W) button once to ad-
vance the time by 1 hour. Hold it down to advance con-
tinuously.
When the 12-hour display is selected, "AM" will change
automatically to "PM".
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME (X or W) button to adjust the min-
utes.
Press the TUNING/TIME (X or W) button once to ad-
vance the time by 1 minute. Hold it down to change the
time in 5 minute intervals.
The hour setting will not advance even if minutes advance
from "59" to "00".
9
Press the MEMORY/SET button.
The clock starts operating from "0" second.
(Seconds are not displayed.)
And then the clock display will disappear after a few sec-
onds.
To see the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The clock display will flash on and off at the push of the
CLOCK button when the AC power supply is restored after
a power failure occurs or after the AC power lead is discon-
nected.
If this happens, follow the procedure below to change the
clock time.
To change the clock time:
1 Press the CLOCK button.
2 Within 5 seconds, press the MEMORY/SET button.
3 Perform steps 6 - 9 above.
To change the time display mode:
1 Perform steps 1 - 2 in the section "RESETTING THE MI-
CROCOMPUTER", on page 32.
2 Perform steps 1 - 9 above.
11