- ページ 32
ステレオシステム Sharp CD-DP2500HのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp CD-DP2500H 37 ページ。 Mini component system
ページを印刷する
(Continued)
(Main unit operation)
USING EXTERNAL UNITS
Downloaded from:
http://www.usersmanualguide.com/
RCA
lead
To the line
output socket
Commercially
available digital
cable
Sleep operation
The radio, compact disc and cassette deck can all be turned
off automatically.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP"
is displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME
(X or W) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the
sleep operation.
3 hours - 5 minutes → 5-minute intervals
5 minutes - 1 minute → 1-minute intervals
3
Press the MEMORY/SET button.
4
The unit will enter the stand-by mode automatically after
the preset sleep time has elapsed.
Note:
Once the sleep time is set, it will remain the same duration
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1
Use a separately available RCA lead to connect the desired
external unit to the VIDEO/AUX 1 or 2 sockets.
(red → right channel, white → left channel)
When using video equipment (Laser Disc player or VCR),
be sure to connect the audio output to this unit and the
video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX (1 V 2) button.
Select either "VIDEO 1" or "VIDEO 2".
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2 - 4
of the "Recording from the built-in radio" section on page 29.
Note:
To prevent hum interference, do not place this unit near tele-
vision receivers.
CD digital output (optical)
The CD digital signal from this unit can be recorded
by other DAT or MiniDisc recorders.
1
Remove the CD DIGITAL OUT socket cover.
2
Use a commercially available digital cable to connect the unit
to the OPTICAL IN socket of a MiniDisc recorder or a DAT.
3
Put the external unit in the recording mode.
4
Play a CD on this unit.
Note:
Only CD signals can be output.
31