- ページ 9

ステレオシステム Sharp CD-E800WのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp CD-E800W 36 ページ。 Mini component system

! Speaker connection

Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
" Use speakers with an impedance of 6 ohms
or more, as lower impedance speakers can
damage the unit.
" Do not mistake the right and the left chan-
nels. The right speaker is the one on the right
side when you face the unit.
" Do not let the bare speaker wires touch
each other.
" Do not stand or sit on the speakers. You may
be injured.
! Placing the speaker system
The left and right speakers have individual shapes. For best perfor-
mance, place the speakers according to the diagram below.
Left speaker
Note:
The speaker grilles are not removable.
! Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into a wall socket. If necessary, adjust
the selector to correspond to the AC power voltage used in your
area.
Turn the selector with a screwdriver until the appropriate volt-
age number appears in the window (110 V, 127 V, 220 V or 230
V - 240 V AC).
! Connecting the AC power lead
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket. If you plug the
unit first, the unit will enter the demonstration mode (see page 9).
Notes:
" The unit will start the tape initialisation when plugged in to the AC
socket. During this process, initialising sound will be heard and
the unit cannot be turned on. Wait until the process is finished.
" Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
Incorrect
230V
240V
Right speaker
03/8/27
Wall socket
(230 - 240 V, 50/60 Hz)
CD-E800W(A)1.fm
TINSE0908AWZZ
CD-E800W
2
8