- ページ 46

オール・イン・ワン・プリンター Sharp AL-1035-WH AのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp AL-1035-WH A 50 ページ。 Digital multifunctional system
Sharp AL-1035-WH A にも：スタートマニュアル (28 ページ)

ページを印刷する

Chapter 6

ROUTINE MAINTENANCE

This chapter explains how to replace the toner and drum cartridge, clean the machine and store the supplies.

REPLACING TONER CARTRIDGES

Please replace the toner cartridge according to the following steps.

The following phenomena indicate that the cartridge has run out of toner, please replace it with a new cartridge.

Note

• When the "toner cartridge replacement required" indicator (

• If the copies show white lines, light-colored printing or fogged image.

Lift the document glass locking

handle and open the cover of the

machine.

Remove the old cartridge following

the upward direction of the arrow.

After removing the old cartridge, do not shake

Caution

it or tap it. Otherwise toner may leak from the

cartridge. Immediately put the old cartridge in

the bag of the new cartridge. Dispose of the

old cartridge according to local regulations.

Take the new cartridge out of the bag,

grasp the cartridge on both sides and

shake it horizontally five to six times.

Please give priority to

using the toner delivered

together with the

machine when using the

toner cartridge for the

first time.

) is on.

Grasp the cartridge grips when holding the

Caution

cartridge.

Hold the new cartridge by its grips,

and insert it at a 45-degree angle

towards the slot. Press it down until a

"click" is heard.

"Click"

Gently lift the support bar at the

green-marks and pull to a half-closed

position, and then gently lift the bar

again until the cover is completely

closed. Connect the power.

• Before closing the cover, make sure that the

Note

new toner cartridge is correctly installed.

• Confirm whether the original is placed slant

or not when making copies again.

If there is any dirt or dust

on the new toner

cartridge, remove it

before installing the

cartridge.

The "toner cartridge

replacement required"

indicator (

) will go

out.