- ページ 6

オール・イン・ワン・プリンター Sharp AR M277 - B/W Laser - CopierのPDF オンラインマニュアルをオンラインで閲覧またはダウンロードできます。Sharp AR M277 - B/W Laser - Copier 36 ページ。 Digital multifunctional system
Sharp AR M277 - B/W Laser - Copier にも：ソフトウェア・セットアップ・マニュアル (18 ページ)

ページを印刷する

Sharp AR M277 - B/W Laser - Copier オンラインマニュアル

Basic printing

Click the "Print" button ("OK" button in

Windows 95/98/Me/NT 4.0).

Printing begins. The print job is delivered to one of the

following trays (depending on which output devices are

installed):

Job separator tray kit is installed: Job separator tray

Finisher is installed: Offset tray

The output tray can be selected in the key operator

Note

programs (see "OUTPUT TRAYS" in the key

operator's guide).

The output tray can also be selected in the print

settings at the time of printing. To change the tray

selection, select the desired tray in "Output" in the

"Paper" tab of the printer driver setup screen.

If the paper type setting in the printer driver is different

from the bypass tray's paper type setting in the

machine, printing may stop. To resume printing, press

the [PRINT] key on the operation panel, touch the

[BYPASS TRAY] key in the touch panel, and specify

the same paper type as in the printer driver.

CONTENTS

I N D E X

When "Paper Selection" is set to "Auto Select"

If "Paper Selection" is set to "Auto Select" in the "Paper" tab of

the printer driver setup screen and the correct size of paper for a

print job is not loaded in the machine, the printing procedure will

vary depending on the "FORCED OUTPUT OF PRINT" setting

in the key operator programs (see the key operator's guide).

When "FORCED OUTPUT OF PRINT" is disabled

If the bypass tray can be used, a message prompting you to

print from the bypass tray will appear in the touch panel.

Press the [PRINT] key on the operation panel, touch the

[BYPASS TRAY] key, load paper in the bypass tray, and then

touch the [BYPASS] key. Printing will begin automatically.

When "FORCED OUTPUT OF PRINT" is enabled

Printing will take place using a size of paper that is close to the

size of the print image.

If the paper is loaded in a different orientation than the

Note

print image, the image is automatically rotated to match

the paper. This setting can be changed in the key

operator programs (see "ROTATED PRINT" in the key

operator's guide).

(part 2)