- ページ 17

オール・イン・ワン・プリンター Sharp AR-5420のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp AR-5420 44 ページ。 Digital laser copier

CONNECTING THE POWER CORD

If you use the unit in a country other than the country where the unit was

purchased, you will need to make sure that your local power supply is

compatible with your model. If you plug the unit into an incompatible

power supply, irreparable damage to the unit will result.

Ensure that the power switch of

the unit is in the OFF position.

Insert the attached power cord

into the power cord socket at the

rear of the unit.

Plug the other end of the power cord into the nearest outlet.

Only insert the power cord into a properly grounded wall socket.

Do not use extension cords or power strips.

Power on

Ensure that the power switch of the unit is

in the OFF position. Plug the other end of

the power cord into the nearest outlet.

Turn the power switch on the left side of

the unit to the "ON" position. The start

(

) indicator will light up and other

indicators which show the initial settings

of the operation panel will also light up to

indicate the ready condition. For the initial

settings, see the "Initial settings of

operation panel" described on the next page.

• The unit will enter a power save mode once the set time has elapsed

without any unit operation. The settings of the power save modes can

be modified. See "USER PROGRAMS" (p.20).

• The unit will return to the initial settings a preset amount of time after

the end of copy or scanning job. The preset amount of time (auto

clear time) can be changed. See "USER PROGRAMS" (p.20).