- ページ 23
オール・イン・ワン・プリンター Sharp AR-M318のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp AR-M318 48 ページ。 Operation manual for network scanner
Sharp AR-M318 にも： 操作マニュアル (4 ページ), セットアップマニュアル (20 ページ)
ページを印刷する
8
Touch the one-touch key of the desired
destination.
READY TO SEND.
TEST1
TEST2
TEST3
TEST4
TEST5
TEST6
TEST7
TEST8
FREQUENT USE
ABCD
EFGHI
JKLMN
OP
• Refer to pages 10 to 13 for information on
Note
programming one-touch key destinations.
• When touching a one-touch key,
corresponding information from the email
destination screen is shown in the
message display.
• The destination e-mail address for Scan to
E-mail can be entered manually, or you
can search for a destination in an LDAP
server on the network (p.22 to 23).
• Multiple destinations can be specified for
a Scan to E-mail transmission (p.22).
9
Enter a file name for the scanned
image. (p.30)
ADDRESS
BOOK
ADDRESS REVIEW
ADDRESS ENTRY
SEND SETTINGS
When sending an image by Scan to E-mail,
Note
a subject and sender's name can be
entered.
Normally the subject and sender are
automatically entered based on the
information stored in "Reply E-mail Address"
in "SMTP Setup" in the Web page.
If user authentication is enabled, the e-mail
address of the user who logged in is used as
the sender.
• To cancel transmission while "SCANNING ORIGINAL." appears in the display or before the [READ-END] key
Note
is touched, press the [CLEAR] key (
the destination and scan settings are saved. To cancel a transmission, press the [JOB STATUS] key and
cancel the job. (p.31)
• If you exceed the number of pages that can be scanned while scanning an original, "THE MEMORY
BECOMES FULL." will appear in the touch panel. To send the data that has been scanned to that point, touch
the [SEND] key. To cancel the transmission, touch the [CANCEL] key.
• If a misfeed occurs while an original is being scanned, remove the original according to the instructions in the
touch panel. To resume scanning after removing the misfeed, press the [START] key (
The key you touched is
highlighted. If you touch
the wrong key, touch the
key again to cancel the
selection. The key
display will return to
normal.
If the send settings are
not changed, a file name
is assigned based on the
items specified in the
Web page.
) or the [CLEAR ALL] key (
HOW TO USE THE NETWORK SCANNER FUNCTION
Using the RSPF
10
Press the [START] key (
Using the document glass
10
Press the [START] key (
11
If you have another page to scan,
change pages and then press the
[START] key (
Repeat this sequence until all pages have been
scanned.
If no action is taken for one minute, scanning
Note
automatically ends and transmission begins.
12
After the final page is scanned, touch
the [READ-END] key.
ESS [START].
EAD-END].
READ-END
). If you press the [CLEAR] key (
).
Scanning begins. When
scanning is finished,
"SENDING. PRESS [C]
TO CANCEL." appears in
the touch panel and
transmission begins.
When transmission is
finished, "SENDING
COMPLETED." appears
in the touch panel.
).
The original is scanned
and the [READ-END] key
appears.
).
"SENDING. PRESS [C]
TO CANCEL." appears in
the touch panel and
transmission begins.
When transmission is
finished, "SENDING
COMPLETED." appears
in the touch panel.
),
).
21
2