- ページ 4

冷蔵庫 Sharp SJ-244SのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp SJ-244S 8 ページ。

Sharp SJ-244S 操作マニュアル

INSTALLATION

WARNING
Do not install the refrigerator in a damp or wet
location as this may cause damage to the
insulation. Condensation may also build on the
outer cabinet and cause rust.
1.
Keep adequate ventilation space around the
refrigerator.
• The figure shows the minimum required space for
installing the refrigerator. The amount of space around
the refrigerator affects the amount of power
consumption.
• Insufficient spacing will decrease cooling efficiency
and increase energy consumption.
This may reduce the life of the unit and void warranty.
2. Using the front adjustable foot, ensure that the
refrigerator is positioned firmly and level on the floor.
3. Connect the power plug to a 230/240 volt. 10 amp.
power point.
NOTE
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to a heat generating appliance.
• This refrigerator is designed for indoor use only, do not
place the unit on an unsealed surface.

OPERATION

Controlling temperatures
• FREEZER TEMP. CONTROL regulates the quantity of
cold air to the freezer.
• With FREEZER TEMP. CONTROL set to MAX, you may
need to adjust the REFRIGERATOR TEMP. CONTROL
to balance the temperatures.
• REFRIGERATOR TEMP. CONTROL controls the
compressor running time of the refrigeration system.
• MAX setting will result in colder temperature in both
(refrigerator and freezer) compartments.
EXTREME AMBIENT TEMPERATURES
During periods of extreme ambient temperatures
(e.g. less than 10°C, or more than 35°C)
you may find it necessary to rebalance the freezer and
refrigerator temperature controls accordingly.
4
90mm
60mm
60mm
Adjustable
foot

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Hints when making ice
1. Do not over fill the Ice cube trays;
otherwise the ice cubes will be
joined together when frozen.
2. When the ice cubes are made, turn
the lever clockwise to empty the ice
into the Ice cube box.
NOTE:
To prevent damage to the Ice cube
box, do not make ice in the Ice cube
box.
Deodorizing unit
A deodorizing catalyst is installed on the routes of cold air.
No operation or cleaning is required.
Defrosting
Defrosting is fully automatic due to a unique energy saving
system.
60mm
a
194S,222S
308S
244S type
339S type
970mm
a
1065mm
b
1145mm
1221mm
Lever
Ice cube box