- ページ 11

冷蔵庫 Sharp SJ-40J-BEのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sharp SJ-40J-BE 32 ページ。

Sharp SJ-40J-BE サービスマニュアル
(4) Check the balance of the door opening force, self-
closing force and roller climbing width between the
left and right sides.
• Referring to the right figure, check the climbing
width.
When the balance is poor between the left and right
sides, proceed with the following work.
(5) Adjust the upper hinge. (Because the position
relationship of the door and hinge varies at the upper
area of the door in Item (3)-1.)
(a) Loosen the screws (6 pieces) on the hinge, and
swing the door forward and backward approx.
5 times. (Snugly fit the hinge to the door.)
(b) Lightly press the door, relocate the upper hinge
toward you, and tighten the screw.
• Check the clearance between the upper hinge
and Door cam upper. If it is rubbed during opening/
closing, insert the spacer (T hinge SPA05) under
the table support.)
(Insert plural spacers according to the adjustment
width.)
Figure F-17
[Details of service parts]
1. Spacer assembly
1 Part code:
*
CSOG-C803CBK0
Components:
Roller spacer
2. Silicon oil
2 Part code:
FPAK-A275CBE0
*
Upper hinge
2 mm or less
Door cam upper
R & L door
Door cam spacer
R & L door
Lower hinge
ass'y
Figure F-13
Upper hinge
Swing the door
forward and backward
approx. 5 times.
Figure F-14
Upper hinge
Lightly press here.
Figure F-15
Figure F-16
T hinge SPA05
(0.5 mm thick on the
left and right sides
as symmetric)
Figure F-18
T hinge SPA05
11
SJ-40J-GY/ BE
SJ-W40J-GY/ BE
SJ-36J-GY/ BE
SJ-W36J-GY/ BE
Door cam bottom
0.5 to 1 mm
(both left and right sides)
Hinge pin
Top hinge cover
Table support
12.5 ±1mm
Relocate the upper
hinge toward you.
Table support
Determine the position
with the screws.
Upper hinge
Table support
Two pieces per each pack.
(They are all 0.5 mm thick.)