ページを印刷する
1. Stick U sealer handle to Fan motor holder a.
Fan motor holder a
Motor
cushion
SEC. C-C
Figure A-17
2. Insert the terminals of Lead e.v. cover ass'y to Fan
motor.
Figure A-18
3. Insert shaft of Fan motor to the hole of Motor cushion.
Set at Fan motor holder a.
Next, insert the boss of rear to the hole of Motor
cushion, set at Fan motor holder b.
Then, fix with Tapping screw (2pieces).
Motor cushion
Fan motor holder a
Figure A-19
C
Motor cushion
C
Fan motor
Lead e.v cover ass'y
Gray
White
Fan motor holder b
Tapping
Fan motor
4. Set Fan clamp to Propeller fan and insert it to the
shaft of Fan motor.
Fan clamp
Fan clamp
right
5. Fix L band c.
Installation of L band c
Cut of top
Not come out of claw
The terminals No. 1, 2 and 4 are completely inserted as
an assembly unit of Lead ev cover assembly.
When assembling the assembly, insert the Def. thermo.
(blue) No. 3 and Thermo. fuse (black) No. 5.
Fan motor(Blue)
Fan motor(Gray)
1
4
Def. thermo. (Blue) Thermo. fuse(Black)
Cautions
1. Don't mistake the insertion direction and position of
the terminal of each lead wire. If it is mistaken,
cooling may be defective.
2. Securely fasten each lead wire.
3. After assembly, verify that the fan motor runs normally.
Otherwise, lead wire may be sometimes in contact
with the end surface of metal and propeller fan.
4. Don't store any part at the area exposed to the direct
sunlight or high temperature. (Because the fuse
assembly is molten at 70°C.)
5. To prevent an electrical part from being rusted, don't
moisten it with water.
19
Propeller fan 100
Fan boss
wrong
Figure A-20
Not come out of claw
Not come out of claw
SEC. B-B
Figure A-21
Def. thermo.(Pink)
2
3
5
6
Thermo. fuse(White)
Figure A-22
SJ-40J-GY/ BE
SJ-W40J-GY/ BE
SJ-36J-GY/ BE
SJ-W36J-GY/ BE