![Sharp SJG2254FS 取扱説明書&取付説明書](/uploads/products/server2/5055122/5055122.jpg)
INSTALLATION INSTRUCTIONS
WARNING
Precautions before installation:
Before installation or adjusting of accessories, it shall be
ensured that the refrigerator is disconnected from power.
Precautions shall be taken to ensure that the handle has been
securely attached in order to prevent personal injury when
opening the door.
INSTALLATION LOCATION
• This refrigerator is designed for indoor, household use only.
• Keep away from heat and avoid direct sunlight or places near
a heat source, such as an oven or a radiator.
• Do not place the refrigerator in moist or damp places to
prevent rust or reduction of its insulating function of the
electrical components and food storage compartments.
• The refrigerator should be placed in a dry and well-ventilated
indoor place.
• The ground shall be level, and sturdy (rotate the adjustable
leg left or right to adjust for leveling if unstable).
• The ambient temperature of the appliance's location should
range from a minimum of 55°F to a maximum of 110°F.
However, for better energy usage and superior cooling, the
temperature is recommended to be between 60°F and 90°F.
• For proper air circulation and electric connections, allow a
3/4" clearance on each side and behind the refrigerator. Allow
a 3/8" clearance at top of the refrigerator.
• Spare enough space for convenient opening of the doors and
drawers, especially when the refrigerator is installed next to
a fixed wall to allow the door to swing open.
DISASSEMBLY OF REFRIGERATOR
DOOR S/DRAWERS
In some cases you need to remove the fridge doors and drawer
doors to move the refrigerator through a doorway. The doors
can be removed by the following steps. IF NOT NECESSARY,
DO NOT REMOVE THOSE DOORS.
DISASSEMBLY OF REFRIGERATOR DOORS
1. Use screw driver to remove the 3 screws, and then remove
the upper hinge cover of the left door. See Figure 1.
2. Press the water line locking ring into place, and then pull the
left door water line from the connector by hand. See Figure 2.
Figure 1
Water line locking ring
Figure 2
8
3. Use the screwdriver to loosen the 3 screws and 1 earth screw
fixing the upper hinge, then remove the plug terminal and
then remove the left door. See Figure 3.
Figure 3
4. The right door has no earth screw. Follow the rest of the steps
for the left door.
DISASSEMBLY OF FLEX DRAWER
1. Open the Flex Drawer to the maximum opening.
2. Lift the tail of the tray by holding both sides with both hands.
See Figure 4.
Figure 4
3. Pull the whole tray toward you about 5/8" until the support
claws of the slide rails are separated from the tray.
4. Remove the tray from the side rails.
5. Remove harness cover with a screwdriver or appropriate
tool. See Figure 5.
Harness
Figure 5
Cover