- ページ 29

釣具 Shimano DENDOUMARU 4000HPのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Shimano DENDOUMARU 4000HP 32 ページ。

ページを印刷する

Troubleshooting

Problem

LCD totally black, and all characters

appear.

Even when connected to 12V battery,

there is no LCD display.

Line winding learning is not set.

Even if line has been delivered, the

counter does not move.

The error is large.

The counter display and line water

depth color does not match.

The gunnel stop position is different.

There is display on the LCD, but the

motor does not work.

The motor stops in the midst of

up-winding.

If it still does not work after the above has been done, then bring it to the dealer you purchased the set from.

Fill in the Repair Card and if possible describe the problems and send to Shimano Service Center.

When exposed to high temperature environment (like in car trunks), it may happen. Reduced the

temperature and it will return to normal.

Check if battery and power cord's (+) and (-) terminals are connected properly. Also check if

battery capacity is sufficient.

It's a bit troublesome, but return to learning, and check.

Depending on type of line, there is some difference, but due to line stretch during use, it may not

match counter display because of slip.

It may be caused by up-winding tension and line stretch. Do zero-setting on the surface. And for

the set that can memorize gunnel, the range is 1-6m.

Sets that has 0-1m setting range should be set at 1m for safety reason.

Check if the battery capacity is sufficient.

* If it works when the motor speed is low, but not when the speed is high, then it's may be due to

battery capacity. Check again after battery re-charge. But if after re-charging it still doesn't work,

then the battery is probably too old. Use new battery and check again.s may be due to

battery capacity. Check again after battery re-charge. But if after re-charging it still doesn't work,

then the battery is probably too old. Use new battery and check again.s may be due to

battery capacity. Check again after battery re-charge. But if after re-charging it still doesn't work,

then the battery is probably too old. Use new battery and check again.

Check if the screw of power connector is properly tightened.

The terminals of vessel power source and the connector of reel and power cord may be rusted

causing poor connection. Check again after removing the rust.

Solution

Reference

P.6

P.7-P.11

P.16-P.17

P.19

P.6