- ページ 6

釣具 Shimano tyrnos seriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Shimano tyrnos series 25 ページ。

HOW A LEVER DRAG OPERATES

Pre-programming and operating your lever drag is very easy. The drag adjustment range is

almost infinite and is based on line strength. The basic formula is to set the "STRIKE" drag at

approximately one-third of the line test. For example, if you are using 20 lb. test, the strike drag

should be no more than 7 lbs. Using 30 lb. test, it should be no more than 10 lbs.

To pre-program the drag:

Start by moving the lever to "FREE" and turning the pre-program knob clockwise to increase the

drag range. Now move the lever forward to the "STRIKE" position where it will automatically stop.

Pull line from the reel or check the scale reading as the line is released. Continue to fine tune your

drag range adjustments (with the lever at "FREE" each time) until you are satisfied with the

tension at "STRIKE". Warning: Always make changes to the pre-programming knob with the

lever in "FREE" because turning the pre-programming knob with the lever in strike may

damage the reel.

Fishing:

Once you have established your drag setting, you can return to the pre-programmed "STRIKE"

settings at all times. Your reel will "remember" this setting forever, so you will never be in doubt

about what drag pressure you are exerting on the fish. If you wish to go past your "STRIKE"

setting to put even more pressure on a fish just depress the strike stop button located in the drag

lever quadrant so you can move the lever toward the "FULL" position. This will gradually increase

the drag force, up to an additional 70%, to its maximum control. This setting is to be used with

caution since the combination of programmed control and increased line leverage may exceed

your line strength. It is recommended that the "STRIKE" setting be checked before each use and

after encountering any long running fish.

Setting the drag...

Strike to Check

Strike Position

Free Spool

Full Drag