ページを印刷するNotice
carefully.
When carrying the assist bicycle in a car, remove the battery from the bicycle and place it on a stable surface in
the car.
Before connecting the battery, make sure that there is no water collecting in the area where the battery will
be connected (connector), and that it is not dirty.
It is recommended to use a SHIMANO genuine battery. If using a battery from another company, be sure to
read the owner's manual thoroughly prior to use.
Connection and communication with PC
The PC linkage device is needed to connect the bicycle to a PC. Using E-TUBE PROJECT Professional enables you
to perform a range of tasks, such as customizing individual components or the entire system, or updating
firmware.
PC linkage device: SM-PCE02
E-TUBE PROJECT Professional: PC application
Firmware: Software inside each component
Connection and communication with smartphone
Components that support Bluetooth
PROJECT Cyclist enables you to perform a range of tasks, such as customizing individual components or the
system, or updating firmware.
E-TUBE PROJECT Cyclist: Application for smartphones
Firmware: Software inside each component
Care and maintenance
Do not use the thinners or harsh solvents to clean the products. Such substances may damage the surface.
When cleaning the products, use a cloth moistened with a neutral detergent diluted with water.
The chainrings and sprockets should be periodically washed with a neutral detergent. In addition, cleaning the
chain with neutral detergent and lubricating it can be an effective way of extending the life of the chainrings,
sprockets, and the chain.
Use a damp, well wrung out cloth, when cleaning the battery and plastic cover.
Assist
The proper level of assistance cannot be achieved unless the proper settings have been made (proper
adjustment of the chain tension, etc.), so consult with the place of purchase.
Open source software
®
LE are required to connect the bicycle to a smartphone. Using E-TUBE
10