- ページ 17
自転車 Shimano STEPS E6000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Shimano STEPS E6000 46 ページ。 Shimano steps e6000 battery and charger
ページを印刷する
3.3
Shifting and tilting the saddle
DANGER
Never clamp the saddle in the curve of the saddle rail; always do it in
the straight section. Only shift the saddle within the straight section
(fig. 1). Saddles that stay clamped outside this area can fail (fig. 2).
correct
Clamping screw
Fig. 1
Use a torque wrench to tighten the clamping screws. Observe the
specified torque setting. If no value is shown on the component, use
the torque settings from the following table:
Thread
Tightening torque [Nm]
M5 / M6 / M8
M5: 5.5 / M6: 5.5 / M7: 14 / M8: 20
Failure to comply can result in screws/bolts becoming loose, tearing
away or fracturing. If that happens while you are riding the bike,
components may come off and you could have a severe crash. If
screws are overtightened, components can also be damaged.
wrong
Fig. 2
3.3.1 S ingle-screw support: Shifting and tilting the saddle
1. Loosen the clamping screw by turning it
anticlockwise. Turn the screw completely
two to three times at most or the whole
mechanism could fall apart.
2. Move the saddle backwards or forwards as
required.
3. Tilt the bicycle saddle to the desired angle.
4. Tighten the clamping screw by turning it clockwise with a torque
wrench.
5. Ensure that the newly-tightened saddle does not tip; test it by pressing
down on the front and back alternately.
Original User Guide | Pedelec Shimano Steps E6000 Version 1
For 1. Loosen the clamping screw
EN-17