- ページ 5

メディア・コンバーター Digital Barriers EdgeVis HD-IP200のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Digital Barriers EdgeVis HD-IP200 13 ページ。

EDGEVIS HD-IP200 HARDWARE INSTALLATION

Powering the device and switching it on/off

The HD-IP200 must be powered using an AC/DC adapter (supplied). To switch the unit on simply connect the output

cable from the AC/DC adapter to the DC input connector on the front panel of the HD-IP200 and connect the AC/DC

adapter to the mains power outlet.

Default LAN port IP Addresses

For ease of deployment each LAN port on the HD-IP200 device is pre-configured with a static IP address:

LAN Port

USB Ethernet

(not supplied)

Connecting IP cameras

The HD-IP200 allows for connection of one IP camera via the ethernet port located on the front of the unit. The

camera should be connected to the device using standard Ethernet cable.

Refer to Section 2 of the IP Series, HD-Q800, 4K-R800 - Setup Guide for details on configuring the Ethernet ports

and IP cameras to work together. The list of specific cameras supported on the IP Series of products can be found on

the Support site:

http://tvi-support.digitalbarriers.com

The HD-IP200 can record video to an external USB storage device. For further details on how to properly prepare a

recording disk refer to Section 2 of the IP Series, HD-Q800, 4K-R800 - Setup Guide.

ISSUED: 17 MARCH 2022

Default IP Address

LAN

192.168.10.1

192.168.12.1

Subnet mask

255.255.255.0

PAGE 5