- ページ 6

デジタルカメラ Digital Barriers BW600のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Digital Barriers BW600 10 ページ。 Body worn cameras

EDGEVIS BODY WORN CAMERAS

Crocodile clip

2) KlickFast™ Adapter for connection to standard KlickFast™ mounts.

Attaching the Crocodile Clip:

Turn the camera so the LCD screen is facing upwards. The U-shaped mount is above the LCD screen.

2) Align the metal clip of the crocodile clip with the camera mount, then slide the clip downwards until it clicks

into place. The centre of the clip should engage with the notch on the back of the BW600.

3) Check that the clip is securely mounted on the camera before attaching it to any clothing.

Attaching the KlickFast Adapter:

The KlickFast adapter is designed to always remain connected to the camera once it has been fitted. Removing the

KlickFast adapter from the camera multiple times is not covered under warranty and will cause the adapter to become

loose over time.

Turn the camera so the LCD screen is facing upwards. The U-shaped mount is above the LCD screen.

2) Align the KlickFast adapter with the camera mount, then slide it downwards until it clicks into place. The

centre of the clip should engage with the notch on the back of the BW600. It may be necessary to press on the

centre pin of the adapter to make it engage with the notch on the BW600.

3) To connect the camera to a standard KlickFast mount rotate the camera until it is upside down. Align the

KlickFast stud on the camera with the KlickFast mount then pull downwards until the camera clicks into place.

Rotate the camera until it is upright. Then check that the camera is securely mounted.

How to Assign a camera

The BW600 can be assigned to an operator by:

Tapping the operator's ID card on an RFID reader; or

2) By assigning the camera from VideoVault

BW600 cameras must be placed in a docking station, must be connected to VideoVault and available for assignment. A

camera is available for assignment if:

•

It has completed uploading all recordings from any previous usage.

•

Battery has been charged for the minimum time-period (this is a configurable setting in VideoVault)

•

The camera is in an unassigned state.

RFID Camera Assignment

Tap the ID card against the card reader. Note that the ID card must have already been registered and

associated with the Operator's account in VideoVault. 3 beep sounds from the card reader indicate that the

card has been read successfully but there is no account associated with it. 2 beep sounds indicate that a

camera has been assigned.

ISSUED: 2 FEBRUARY 2021

PAGE 6