- ページ 9

配電ユニット Crestron Electronics M201907002のPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Crestron Electronics M201907002 12 ページ。 Fliptop ac power outlet module, single, jp nema 5, type b

ページを印刷する

Install the Module

Install the power outlet module into the FT2 FlipTop assembly. This procedure assumes the power outlet

module is being added to an FT2 FlipTop assembly with modules already installed. If the bezel and

locking bars have not been installed on the FT2 FlipTop assembly, skip to step 6. To install the power

outlet module:

NOTE: For ease of installation, install power outlet modules before installing any other module.

1. Tap the lid retraction button to retract the one-touch lid, which descends into the FT2 FlipTop

assembly. If the assembly has two lids, open both.

2. Remove and retain the magnetic bezel from the FT2 FlipTop assembly by grasping the inside of

the bezel and firmly pulling it up and away from the assembly until the magnetic hold is broken.

3. Using a manual torque screwdriver, unscrew and remove and retain the two locking bars on either

side of the module row where the power outlet module is to be installed.

4. Lift and remove any module being replaced by a power outlet module.

5. Insert the power cable of the power outlet module through the empty module slots.

Product Manual — Doc. 9401A

FT2A-PWR-JP-1-BASIC • 9