- ページ 5

コントロールパネル DIGITAL DELAY 1020-SCRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DIGITAL DELAY 1020-SCR 10 ページ。

+12VDC Terminal:

Volt source with enough amperage capable of driving the transbrake.

(Using an in-line fuse just large enough to handle the current draw

of the transbrake solenoid, normally 15 Amps., is recommended.)

Transbrake Terminal:

Transbrake solenoid. Connect the low side of the 2-Step, the red

wire, here if used.

When entering new information into the unit, there

must be a number (0-9) in every valid space on the

display or the transbrake terminal will not function.

Ground Terminal:

on the battery or to a good steel ground, not aluminum.

Button-1 Terminal:

connected to Button-1 terminal is used to control the primary

delay and the secondary delay in sequence. In dual Push Button Mode

the push button connected to Button-1 terminal is used to control

the primary delay only.

Button-2 Terminal:

connected to Button-2 terminal is used to control the recovery

if turned on. In dual Push Button Mode the push button connected to

Button-2 terminal is used to control the secondary delay only.

Tap Terminal:

button to the Tap terminal. This allows you to subtract or add a

programmable amount of time from the first delay time started

every time the Tap Push Button is depressed.

Note: In single Push Button Mode the Tap Up or Down only affects the

primary delay and has no effect on the secondary delay.

The Terminal Strip

Connect the +12VDC terminal to a switched +12

Connect the Transbrake terminal to the

Connect the Ground terminal to the Neg. terminal

In single Push Button Mode the push button

If taping up or down is desired connect a push