- ページ 8

コントロールパネル DIGITAL DELAY 1020-SCRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DIGITAL DELAY 1020-SCR 10 ページ。

Setting Dial-In and Delay Times

To enter a new Dial-In or Delay Time, first press a numerical key

(1-4) on the keypad to bring up the current stored time. Then press the * key on the keypad. The display

will go blank indicating it is ready to accept a new time. Next use the numerical keys to enter the new

four digit time into memory, leading zeros must be entered. As the numbers are entered they will appear

on the display indicating the number was accepted and stored into memory. Once the * key is pressed all

four digits must be entered before any other function of the delay box will work.

If an error is made while entering, press the * key to erase the last digit entered. This can be

repeated as many times as necessary until the display is blank.

To enter a new Recovery Time, first press the 8 key on the keypad to bring up the current

Recovery Time stored in memory. Then press the * key on the keypad. The display will go blank

indicating it is ready to accept a new time. Next use the numerical keys to enter the new three digit time

into memory, leading zeros must be entered. As the numbers are entered they will appear on the display

indicating the number was accepted and stored into memory. At any time after pressing the * key and

before entering the third digit, pressing # will either turn on the Recovery along with the arrow in the

display or turn both off. Once the * key is pressed all three digits must be entered before any other

function of the delay box will work..

If an error is made while entering, press the * key to erase the last digit entered. This can be

repeated as many times as necessary until the display is blank.

For the Recovery to work, the Crossover Plus must be in Single Push Button mode with the

Recovery turned on and have a push button connected to the Second Push Button Terminal. If the

Recovery is on and the push button connected to the Second Push Button terminal is pressed, after the

primary delay or secondary delay was started and before the Transbrake has released both the primary and

secondary delays will be canceled. When the push button is then released the Recovery time starts

counting down to zero. When the count reaches zero the transbrake will be released.

Setting the Recovery