- ページ 4

エンクロージャー Bitspower TITAN XのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Bitspower TITAN X 4 ページ。

ページを印刷する

Pour the coolant into the reservoir via the water filling hole. Once the reservoir is 90% full,

turn on the power supply for the pump to run and let the air exit the loop. Turn off the

power supply when the reservoir is near empty. Repeat until all the air has exited the loop.

Notice : Do not turn on the pump if the reservoir is empty.

Bitspower recommends that consumers add the Bitspower coolant or

purified water for their water-cooling liquid. If the consumer chooses

different water-cooling liquids , the resulting impurities may cause

peeling of the coating on some of the hardware, water channels block-

age by built-up residue, improper operation of the water pump, water

tank tube breakage, and o-rings deformation leading to leakage. Any

issues related to the use of inappropriate water-cooling liquid will be

the responsibility of the consumer.

III. BPTA-O11D-AK

backplate / control panel / top cover

A B

C D

A Negative electrode -

B positive electrode +

C Speed signal

CPU_FAN

Pump Spec.

Rated voltage：12V DC

Power consumption：8.4W

Maximum flow：460±15%L/h

Noise：≦24dBA

PWM：Yes

MTBF：≦15,000 hours

Warranty：2 years

AIO_PUMP

Before installing the water cooling parts

for the graphics card, please cut the soft

tube as shown in the figure and remove

the BP-BB2WP-P02.

BPTA-EFW

It is recommended to install the water-exhaust

fitting at the lowest point of the water cooling

system.

Step 1

Unscrew the top of the water-exhaust fitting.

Step 2

Replace with the water-exhaust part. When

screwing in the part, water will start to

discharge, it is recommended to connect

tubing beforehand to control the water outflow.

— 4 —

Water filling hole

BP-BB2WP-P02

90% full