- ページ 3

アクセサリー Accutrol ZPS-HのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Accutrol ZPS-H 4 ページ。 (zone presence sensor for fume hood applications

STEP 2: START UP

2a. Power up

Apply Power to unit and wait for LEDs to illuminate.

LED lights solid (Green = no detection, Red = detection)

2b. Adjustment of Switch Positions

Verify all switch positions are set to factory default as shown to the right.

Note: Factory Default Switch Positions are Highlighted grey.

2c. Adjustment with Cover Off

To quickly adjust pattern, press and release the Reset Button and then press and hold the Install Button for 3 seconds

(the LED will flash orange to confirm). This puts the ZPS-H into an install mode that is constantly sensing, but not

driving the signal to the AVC. Test unit by walking in and out of the area in front of the hood, watch the LED and it will

turn red when it senses a person.

The sensor should be activated regardless if the person walks towards or away from it. If the unit does not sense

presence appropriately, tip the sensor head in or out until it does. Walk in and out of the area several times to test.

2d. Sensitivity Adjustment

If you need to increase the sensitivity of the ZPS-H, adjust the knob marked "range" clockwise. When you are satisfied

with the sensitivity of the unit, depress the Reset Button again and the ZPS-H will go into Normal Operating mode.

www.accutrolllc.com

Install Button

NOT USED

FAILSAFE

OFF

HPR OFF

NOT USED

DEPART

BI-

DIRECTION

Reset Button

Range Sensitivity

ZPS-H QUICK START GUIDE Rev. L 11/4/2020

SWITCH POSITION

DESCRIPTIONS

LEFT

RIGHT

NOT USED

FAILSAFE

HPR ON

NOT USED

APPROACH

UNI-

DIRECTION