- ページ 5

携帯電話 Samsung Anycall SGH-N700のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Samsung Anycall SGH-N700 36 ページ。 Samsung mobile phone service manual

2 . S G H - N 7 0 0

C i r c u i t

1. SGH-N700 RF Circuit Description

1) RX PART

1. FEM(U402(SWITCHPLEXER+FILTER)) ¡æ Switching Tx, Rx path for E`GSM900, and DCS1800 by logic controlling.

2. FEM Control Logic (U402) ¡æ Truth Table

DCS / PCS Tx Mode

GSM Tx Mode

GSM / DCS Rx Mode

3. FILTER

To convert Electromagnetic Field Wave to Acoustic Wave and then pass the specific frequency band.

- GSM FILTER (U402(SWITCHPLEXER+FILTER)) ¡æ For filtering the frequency band between 925 ~ 960 MHz

- DCS FILTER(U402(SWITCHPLEXER+FILTER)) ¡æ For filtering the frequency band 1805 and 1880 MHz.

4. VC-TCXO (OSC401)

To generate the 13MHz reference clock to drive the logic and RF.

After additional process, the reference clock applies to the U900 Rx IQ demodulator and Tx IQ modulator.

The oscillator for RX IQ demodulator and Tx modulator are controlled by serial data to select channel and use fast lock

mode for GPRS high class operation.

5. SI 4205 (U404)

This chip integrates two differential-input LNAs.

The GSM input supports the E-GSM, DCS input supports the DCS1800. The LNA inputs are matched to the 200 ohm

differential output SAW filters through eternal LC matching network.

Image-reject mixer downconverts the RF signal to a 100 KHz intermediate frequency(IF) with the RFLO from frequency

synthesizer. The RFLO frequency is between 1849.8~1879.9MHz.

The Mixer output is amplified with an analog programmable gain amplifier(PGA), which is controlled by AGAIN.

The quadrature IF signal is digitized with high resolution A/D converts (ADC).

Also, this chip down-converts the ADC output to baseband with a digital 100 KHz quadrature LO signal. Digital

decimation and IIR filters perform channel selection to remove blocking and reference interface signals.

After channel selection, the digital output is scaled with a digital PGA, which is controlled with the DGAIN. DACs drive

a differential analog signal onto the RXIP, RXIN, RXQP, RXQN pins to interface to standard analog-input baseband IC.

D e s c r i p t i o n

VC1

SAMSUNG Proprietary-Contents may change without notice

This Document can not be used without Samsung's authorization

2- 1

VC2