- ページ 5

プリンター Digital Equipment PrintServer 32のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Digital Equipment PrintServer 32 6 ページ。 Controller firmware version 3.6 upgrade
Digital Equipment PrintServer 32 にも：取扱説明書 (20 ページ)

ページを印刷する

Veriﬁcation

Procedure

Extract the existing ROM chips (

screwdriver underneath each chip and gently loosening the

pins from their sockets.

Carefully align the pins on each new chip with the sockets on

the board, noting the orientation of the notch (

Note: You may ﬁnd it easier to align the pins with the sockets

if you bend in the pins slightly. The pins bend easily, so gently

rock each chip on its side, on your ﬂat work surface, to adjust

the pins for alignment.

Press the chips ﬁrmly and evenly to seat them in their sockets.

Slide the controller board back into the unit.

Replace the grounding bracket and tighten the captive screws.

Replace the card cage cover and tighten the captive screws.

10.

Reconnect the power cord and the Ethernet cable.

11.

To verify correct installation of the chips, power on the printer.

The power-up diagnostics run and the following display appears

on the operator panel:

XX-XX-XX-XX-XX-XX

2.1

If the operator panel is blank, either the board is not fully seated

or the chips are not installed correctly.

Installing the Firmware

) by sliding the ﬂat blade