- ページ 17

産業機器 Siemens SIMATIC ET 200SP HAのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Siemens SIMATIC ET 200SP HA 32 ページ。 Distributed i/o devices busadapter for distributed i/o
Siemens SIMATIC ET 200SP HA にも：マニュアル (50 ページ), マニュアル (34 ページ), マニュアル (38 ページ), 設備マニュアル (44 ページ), 設備マニュアル (50 ページ), 設備マニュアル (38 ページ), 設備マニュアル (46 ページ), 設備マニュアル (42 ページ), 設備マニュアル (44 ページ), 設備マニュアル (36 ページ), 設備マニュアル (38 ページ)

Maintenance

5.1

The device name of the distributed I/O device is saved at the following locations when

transferring the device name to the distributed I/O:

● In the BusAdapter

● In the interface of the distributed I/O device (e.g. interface module or I/O device itself)

Note

Replacing a BusAdapter (removing/inserting)

Removing/inserting the BusAdapter under voltage is prohibited.

Device replacement without transfer of topological configuration

The following scenarios are the result of saving the device name on the BusAdapter and in

the interface when exchanging the two components:

BusAdapter non-programmed

(without device name)

BusAdapter with device name

Note

Restoring the factory settings

Not possible for ET 200SP HA:

The reset to factory settings deletes the device name in the interface and in the BusAdapter.

Avoiding deleting of the device name in the BusAdapter:

Proceed as follows:

1. Pull the BusAdapter from the distributed I/O device.

2. Restore the factory settings of the distributed I/O device.

Interface Module IM 155-6 PN HA (6DL1155-6AU00-0PM0)

Manual, 05/2017, A5E39262148-AA

Interface non-program‐

med

(without device name)

No device names

When the supply voltage is switched on, the device name is copied

from the BusAdapter to the interface.

Interface with device name

When the supply voltage is switched on,

the device name is copied from the inter‐

face to the BusAdapter.