- ページ 26

産業機器 Siemens SIMATIC ET 200SP HAのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Siemens SIMATIC ET 200SP HA 50 ページ。 Distributed i/o devices busadapter for distributed i/o
Siemens SIMATIC ET 200SP HA にも： マニュアル (32 ページ), マニュアル (34 ページ), マニュアル (38 ページ), 設備マニュアル (44 ページ), 設備マニュアル (50 ページ), 設備マニュアル (38 ページ), 設備マニュアル (46 ページ), 設備マニュアル (42 ページ), 設備マニュアル (44 ページ), 設備マニュアル (36 ページ), 設備マニュアル (38 ページ)

ページを印刷する
Siemens SIMATIC ET 200SP HA マニュアル
Displays and interrupts
5.1 Status and error displays of the I/O module DI 16xNAMUR HA
DIAG LED
Table 5-1
DIAG LED
MT LED
Table 5-2
Channel status/channel error LED
The green channel status LED shows the signal state of the input at the enabled channel.
The red channel fault LED lights up when a channel diagnostics is active at an enabled channel.
If inversion is enabled, the channel status LED shows the inverted status of the signal applied
to the terminal.
Table 5-3
Channel status
26
Diagnostics display of the DIAG LED
Meaning
The power supply of the ET 200SP HA is disrupted or switched off
Off
Module is not configured.
Flashing
Module is configured, a diagnostics message is not pending.
On
Module is configured, at least one diagnostic message is pending.
Flashing
Status display of the LED MT
MT LED
Meaning
No maintenance required.
Off
Maintenance is required, i.e. at least one maintenance event has occurred.
On
Status and error display of the LEDs channel status and channel error
Channel fault
LED
LED
Off
Off
On
Off
Off
On
On
On
Meaning
● Channel disabled or module switched off
● Process signal = 0, channel enabled and no channel
diagnostics pending
● Module diagnostics pending
Process signal = 1, channel enabled and no channel diagnostics /
module diagnostics pending
Process signal = 0, channel enabled and channel diagnostics
pending
Process signal = 1, channel enabled and channel diagnostics
pending
Digital Input Module DI 16xNAMUR HA (6DL1131-6TH00-0PH1)
Manual, 11/2017, A5E39293880-AB