- ページ 13
産業機器 Siemens SIMATIC ET 200SP HA DQ 32x24VDC/0.5A HAのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Siemens SIMATIC ET 200SP HA DQ 32x24VDC/0.5A HA 38 ページ。 Digital output module
Siemens SIMATIC ET 200SP HA DQ 32x24VDC/0.5A HA にも： 設備マニュアル (36 ページ)
ページを印刷する
4.2
Pin assignment of the I/O module DQ 32x24VDC/0.5A HA (2-wire
connector)
General pin assignment with potential distributor
● The pin assignment on the left side of the terminal block corresponds to the assignment in
the section "Pin assignment of the I/O module DQ 32x24VDC/0.5A HA (1-wire connector)
(Page 11)".
● The potential distributor with 36 M terminals is located on the right side of the terminal block.
Note
Connection information
● The M terminals on the potential distributor are intended exclusively for the loads connected
to the I/O using 2-wire connection system. You may not use these terminals as the ground
terminals for other devices in the system.
● Ensure that the total current does not exceed 10 A overall.
Recommendation: Use terminal blocks with potential distributors
For the connection of actuators with 2 wires, the following terminal block should be used:
Article No.
6DL1193-6TP00-0DN0
6DL1193-6TP00-0BN0
Connection of actuators with potential distributor
The figure below shows the connection of actuators with potential distributor.
This connection variant is approved only for terminal blocks with potential distributor.
Additional information
You can find additional information on the configuration in the system manual
Distributed I/O System; ET 200SP HA .
Digital output module DQ 32x24VDC/0.5A HA (6DL1132-6BL00-0PH1)
Manual, 09/2018, A5E39265993-AA
4.2 Pin assignment of the I/O module DQ 32x24VDC/0.5A HA (2-wire connector)
Function/parameter
Allow new potential group (light terminal block)
Use potential group of the left module (dark terminal block)
Wiring
SIMATIC;
13