- ページ 6

産業機器 Siemens SINAMICS S120のPDF はじめにをオンラインで閲覧またはダウンロードできます。Siemens SINAMICS S120 32 ページ。 Applications for cabinet modules, liquid-cooled
Siemens SINAMICS S120 にも：取扱説明書 (20 ページ), マニュアル (41 ページ), 簡単な説明 (22 ページ), マニュアル (43 ページ), マリンドライブ用キャビネットへの取り付け説明書 (28 ページ), アプリケーション・マニュアル (34 ページ), アプリケーション・マニュアル (46 ページ), 取扱説明書 (22 ページ), はじめに (32 ページ), 取扱説明書 (21 ページ), エンジニアリング・マニュアル (30 ページ), コミッショニング・マニュアル (20 ページ)

Preface

Safety notices

 Commissioning is absolutely prohibited until it has been completely ensured that the

 SINAMICS devices and AC motors must only be commissioned by suitably qualified

 The personnel must take into account the information provided in the technical customer

 When electrical equipment and motors are operated, the electrical circuits automatically

 When the machine or system is operated, hazardous axis movements can occur.

 All of the work carried-out on the electrical machine or system must be carried-out with it

 SINAMICS devices with three-phase motors must only be connected to the power

 The successful and safe operation of this equipment and motors is dependent on

 For special versions of the drive units and motors, information and data in the Catalogs

 In addition to the danger and warning information provided in the technical customer

 Only protective extra-low voltages (PELV, DVC-A) that comply with EN 60204-1:2006

 The motors can have surface temperatures of over +80 °C.

 This is the reason that temperature-sensitive components, e.g. cables or electronic

 When attaching the connecting cables, you must ensure that:

DANGER

machine, in which the components described here are to be installed, is in full

compliance with the provisions of the EC Machinery Directive.

personnel.

documentation for the product, and be familiar with and follow the specified danger and

warning notices.

conduct a dangerous voltage.

in a no-voltage condition.

supply via an AC-DC residual-current-operated device with selective switching once

verification has been provided that the SINAMICS device is compatible with the

residual-current-operated device in accordance with IEC 61800-5-1, Section 5.2.11.2.

WARNING

correct transport, proper storage, installation and mounting as well as careful operator

control, service and maintenance.

and quotations additionally apply.

documentation, the applicable national, local, and plant-specific regulations and

requirements must be taken into account.

can be connected to the connections and terminals between 0 V and 48 V.

CAUTION

components may neither be in contact nor be attached to the motor.

– they are not damaged

– they are not under tension

– they cannot come into contact with any rotating parts

Getting Started, 11/2009, 6SL3097-4AG00-0BP0

Getting Started