- ページ 13

産業機器 Siemens SINUMERIK 808DのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Siemens SINUMERIK 808D 46 ページ。 Connecting with v60 driver
Siemens SINUMERIK 808D にも： 取扱説明書 (34 ページ), サービスマニュアル (48 ページ), 使用方法 (2 ページ), インストレーション・マニュアル (48 ページ)

ページを印刷する
Siemens SINUMERIK 808D サービスマニュアル
Service case
硬件故障
硬件故障
硬件故障
硬件故障
of hardware
服务案例
服务案例
服务案例
服务案例
fault
Feed axis
fault
进给轴故障
进给轴故障
进给轴故障
进给轴故障
Fault description:
The system has completed the state of returning to the reference point
1. The screen can display feed axis data, but the actual machine cannot move
2. The actual direction of motion is opposite to the operational direction of
the machine / is opposite to the direction of screen display.
Diagnostic steps
If the fault is ： The screen can display feed axis data, but the
Case1
actual machine cannot move.
若故障为：屏幕上有进给轴移动数值显示,但实际机械不动
Please check whether the PPU is in the program
test state.
1. Whether the indicator light of the
"Program test" button on the MCP is on (it
should not be on).
2. Whether the "PRT" indicator on the PPU
screen is activated (it should not be activated).
Check whether the mechanical coupling is loose.
Check whether the connection between the axis signal and the drive is
good, and whether the pins on the V60 are tight/damaged.
Check whether there are alarms on the drive if using a third-party drive.
Replacement and maintenance are necessary if the fault still exists after the
above inspection, because it is probable that the PPU is damaged.
808D turning and milling

If the fault is: The actual direction of motion is opposite to the
Case2
若故障为：机床实际移动方向与操作方向相反 / 机床实际移动方向
operational direction of the machine / is opposite to the direction
情况2
of screen display.
与屏幕显示方向相反
Check whether the connections of the direction
keys on the V60 drive are correct.
检查 V60 驱动器上的方向键连接线是否正确
Check whether the wiring of terminal + DIR / -
端子 DR / DR 的接线与实际相比是否接反
DIR is correct depending on the actual situation.
MD32100 / MD32110
检查机床数据
Check whether the settings of machine data
MD32100：轴反向键(默认值 =1,根据需要可调整为 1)
correct.
MD32110：编码器位置反馈极性键(默认值 =1,根据需要可调整为 1)
MD32100 ： Axis reverse key (The implied value = 1. It is permitted to
change to -1 according to the actual situation.)
MD32110 ： Encoder position feedback polarity key (The implied value
= 1. It is permitted to change to -1 according to the actual situation.)
page 13


设置是否正确
MD32100 / MD32110
are
Service guide