- ページ 19

IP電話 Cisco 3600 SeriesのPDF コンフィギュレーション・ノートをオンラインで閲覧またはダウンロードできます。Cisco 3600 Series 23 ページ。 Memory upgrade
Cisco 3600 Series にも：製品概要 (10 ページ), アップグレード手順 (30 ページ), オーナーズマニュアル (17 ページ), アプリケーションノート (41 ページ), 設定マニュアル (36 ページ), ユーザーマニュアル (25 ページ), 付録 (15 ページ), ユーザーマニュアル (7 ページ), マニュアル (5 ページ), コンフィギュレーション・ノート (18 ページ), コンフィギュレーション・ノート (25 ページ)

Figure 21

Cisco 3640 DC-Input Power Supply Connections

Ground

Terminal block

Turn ON the power switch. The power LED on the front panel of the router should go

Step 3

ON.)

Verify that the OK LED on the right side of the front panel goes ON after a few seconds'

Step 4

delay when booting. If you have problems, see the next section, "Troubleshooting," and

the section "Obtaining Service and Support" later in this document.

Secure all power cabling when installing this unit to avoid disturbing ﬁeld-wiring

Warning

connections. (To see translated versions of this warning, refer to the Regulatory Compliance and

Safety Information document that accompanied the router.)

This equipment is intended to be grounded. Ensure that the host is connected to earth

Warning

ground during normal use. (To see translated versions of this warning, refer to the Regulatory

Compliance and Safety Information document that accompanied the router.)

Negative

Terminal block

Cisco 3600 Series Power Supply Configuration Note

Replacing Connections to the Router

Positive

On/off