- ページ 13

IP電話 Cisco 3600 SeriesのPDF コンフィギュレーション・ノートをオンラインで閲覧またはダウンロードできます。Cisco 3600 Series 25 ページ。 Memory upgrade
Cisco 3600 Series にも：製品概要 (10 ページ), アップグレード手順 (30 ページ), オーナーズマニュアル (17 ページ), アプリケーションノート (41 ページ), 設定マニュアル (36 ページ), ユーザーマニュアル (25 ページ), 付録 (15 ページ), ユーザーマニュアル (7 ページ), マニュアル (5 ページ), コンフィギュレーション・ノート (23 ページ), コンフィギュレーション・ノート (18 ページ)

Step 2

Figure 7

1. Pull the locking spring clips outward.

Step 3

Step 4

Installing DRAM SIMMs

Follow this procedure to install DRAM SIMMs:

Step 1

Caution

damaged by mishandling.

Step 2

Step 3

Step 4

Remove one SIMM at a time, beginning with the SIMM in bank 3. To lift the SIMM out

of its socket, pull the locking spring clips on both sides outward and tilt the SIMM toward

the right side of the chassis, free of the clips. (See Figure 7.)

Removing DRAM SIMMs

Hold the SIMM by the edges with your thumb and index ﬁnger and lift it out of the socket.

Place the removed SIMM in an antistatic bag to protect it from ESD damage.

Repeat Step 2 and Step 3 for each SIMM.

Find the DRAM SIMM sockets on the motherboard, as shown in Figure 4 or Figure 5.

Handle SIMMs by the card edges only. SIMMs are ESD-sensitive components and can be

Hold the SIMM with the polarization notch on the right, near the front of the chassis, and

the component side away from you, with the connector edge at the bottom. (See

Figure 6.)

Beginning with bank 0, insert the SIMM into the connector slot at an angle, tilted toward

the right side of the chassis. Rock the SIMM into a vertical position (see Figure 8), using

the minimum amount of force required. When the SIMM is properly seated, the socket

guide posts ﬁt through the alignment holes, and the connector springs click into place.

Ensure that each SIMM is straight and that the alignment holes (as shown in Figure 7)

line up with the plastic guides on the socket.

Top view

Front of chassis

2. Push the top of the

SIMM forward and down.

Cisco 3600 Series Memory Upgrade Configuration Note

Upgrading DRAM

SIMM

polarization

notch