- ページ 22

IP電話 Cisco 3600 SeriesのPDF コンフィギュレーション・ノートをオンラインで閲覧またはダウンロードできます。Cisco 3600 Series 25 ページ。 Memory upgrade
Cisco 3600 Series にも：製品概要 (10 ページ), アップグレード手順 (30 ページ), オーナーズマニュアル (17 ページ), アプリケーションノート (41 ページ), 設定マニュアル (36 ページ), ユーザーマニュアル (25 ページ), 付録 (15 ページ), ユーザーマニュアル (7 ページ), マニュアル (5 ページ), コンフィギュレーション・ノート (23 ページ), コンフィギュレーション・ノート (18 ページ)

Replacing Connections to the Router

Figure 17

Replacing Connections to the Router

Follow these steps to make ﬁnal connections to the router:

Warning

see translated versions of this warning, refer to the Regulatory Compliance and Safety Information

document that accompanied the router.)

Step 1

Step 2

Step 3

Step 4

22 Cisco 3600 Series Memory Upgrade Conﬁguration Note

Replacing the Cisco 3640 Cover

Read the installation instructions before you connect the system to its power source. (To

Replace all network connections.

If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase

power source that provides power within the acceptable range (100 to 240 VAC, 50 to

60 Hz).

If you have a DC-powered router, remove the tape from the circuit breaker switch handle

and reinstate power by moving the handle of the circuit breaker to the ON position.

Turn ON the power switch. The power LED on the front panel of the router should go

ON.)

Check the OK LED on the right side of the front panel to verify that it goes ON after a

few seconds delay when booting. If you have problems, see the next section, "Obtaining

Service and Support."