- ページ 24
オーブン Siemens CD914GX 1 SeriesのPDF ユーザーマニュアルと設置手順をオンラインで閲覧またはダウンロードできます。Siemens CD914GX 1 Series 44 ページ。
ページを印刷する
en Disposal
Fault
Appliance prompting
you to fill water tank
even though water
tank full.
Appliance prompting
you to fill water tank
even though water
tank not yet empty/
appliance not prompt-
ing you to fill water
tank even though wa-
ter tank empty.
A message that
reads "Fill water
tank?" appears on
the display when the
appliance is in opera-
tion.
"Appliance heating
up" appears on the
display but the appli-
ance is not reaching
the selected temper-
ature.
When cooking with
steam, a lot of steam
is produced.
When cooking with
steam, a lot of steam
is produced and this
happens repeatedly.
Steam escaping from
ventilation slots dur-
ing cooking.
Home Connect is not
working properly.
16.2 Replacing defective LED lights
▶
Defective LED lights may be replaced by the manu-
facturer, their customer service or a qualified techni-
cian (electrician) only.
16.3 Replacing the door seal
If the cooking compartment's outer door seal is defect-
ive, you must replace the door seal. Replacement seals
for your appliance can be obtained from our after-sales
service. Specify the E number and FD number of your
appliance.
1.
Open the appliance door.
17 Disposal
17.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
24
Cause and troubleshooting
Water tank not inserted correctly.
▶
Slide the water tank in until it clicks into place.
Detection system not working.
▶
Call the after-sales service.
Water tank dirty and moving water level indicators jammed.
1.
Shake and clean the water tank.
2.
If the jammed parts cannot be freed, order a new water tank from our after-sales service.
Water tank half full.
▶
For longer operations, completely fill the water tank.
Automatic calibration values are not optimal.
▶
Restore the appliance's factory settings and repeat the procedure for initial configuration.
→ "Basic settings", Page 15
→ "Before using for the first time", Page 8
a The next time you use the steam function at 100 °C, the calibration runs automatically.
This generates more steam.
The appliance is being automatically calibrated.
No action required.
Appliance unable to calibrate itself automatically if cooking times too short.
▶
Restore the appliance's factory settings and repeat the calibration process.
This is standard procedure.
No action required.
Different causes are possible.
▶
Go to www.home-connect.com.
2.
Remove the old door seal.
3.
Push the new door seal in on one side of the cook-
ing compartment and then work it in all the way
round.
The joint must be at the side.
4.
Check that the seal is correctly fitted, especially in
the corners.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.