- ページ 14

オーブン Siemens CM724G1B1のPDF ユーザーマニュアルと設置手順をオンラインで閲覧またはダウンロードできます。Siemens CM724G1B1 44 ページ。

Siemens CM724G1B1 ユーザーマニュアルと設置手順
en Time-setting options
This will ensure that the light in the cooking com-
partment is always off while the appliance is in oper-
ation and when you open the appliance door.
Change the "Standby screen" basic setting to "Off".
2.
→ "Basic settings", Page 19
This means that the display always remains off dur-
ing operation.
Set the required operating mode.
3.
→ "Setting an operating mode", Page 13
→ "Setting the type of heating and the temperature",
Page 13
Set the required cooking time depending on the op-
4.
erating mode.
→ "Setting the cooking time", Page 14
→ "Time-setting options", Page 14
Use "End time" to set the time at which the opera-
5.
tion should end.
→ "Setting the end time", Page 14
9  Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting
Use
option
Cooking time
If you set a cooking time, the appli-
​ ⁠
ance stops heating automatically
once this time has elapsed.
End time
​ ⁠
Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer
​ ⁠
You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
9.1 Setting the cooking time
You can set the cooking time for the operation of up to
24 hours.
Requirement: An operating mode and temperature or
setting have been set.
1.
Press "Cooking time".
To set the cooking time, press the relevant time
2.
value, e.g. hour display "h" or minute display "min."
a The selected value is marked in blue.
Set the cooking time using
3.
adjustment bar.
If required, use
​ ⁠ to reset the adjustment value.
Press "Apply".
4.
Use
​ ⁠ to start the operation.
5.
a The appliance starts to heat and the time counts
down.
a Once the cooking time has elapsed, a signal tone
sounds. A note appears on the display confirming
that the operation has finished.
Once the cooking time has elapsed:
6.
14
​ ⁠ or
​ ⁠ or directly via the
→ "Time-setting options", Page 14
Place the food in the cooking compartment before
6.
the appliance starts to heat.
Start the operation.
7.
a The display shows the start time. The appliance is in
standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
8.
When the operation has ended, remove the food
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
Note: If necessary, change the basic setting for the
lighting and the standby screen again.
If required, you can select other settings and re-
start the operation.
When the food is ready, use
pliance off.
Changing the cooking time
You can change the cooking time at any time.
Press the cooking time.
1.
Change the cooking time using
2.
via the adjustment bar.
Press "Apply".
3.
Cancelling the cooking time
You can cancel the cooking time at any time.
Press the cooking time.
1.
Reset the cooking time using
2.
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
Press "Apply".
3.
9.2 Setting the end time
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
Notes
¡ To achieve good cooking results, do not delay the
time once the operation has already started.
¡ Food will spoil if you leave it in the cooking com-
partment for too long.
Requirements
¡ An operating mode and temperature or level have
been set.
¡ A cooking time is set.
Press "Ready at".
1.
Use
​ ⁠ or
​ ⁠ to delay the time.
2.
If required, use
​ ⁠ to reset the setting value.
Press "Apply".
3.
Press
​ ⁠ to start the operation.
4.
a The display shows the start time. The appliance is in
standby mode.
​ ⁠ to switch the ap-
​ ⁠ or
​ ⁠ , or directly
​ ⁠ .