- ページ 20

洗濯機 Siemens TOP WD 1200のPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Siemens TOP WD 1200 28 ページ。

ページを印刷する

Troubleshooting

! Only qualified technicians are permitted to repair electrical appliances. Repairs done by

unauthorised persons can lead to considerable damage.

Problems

The power indicator light

does not illuminate

The door lock indicator light

does not work correctly

Power failure

Washing sequence does not

start

No washing operation

No water to be seen during

washing

Poor washing results

Foam comes out of the

detergent drawer

Foam still visible after last

rinse

Motor noise

Pump noise

Vibrations when washing

and spinning

Machine does not spin or

does not pump out the water

The gasket is crimped

Possible causes / remedies

- The plug is not correctly, or only loosely, inserted into the socket.

- A fuse has blown in the domestic wiring.

- Power failure.

Door not properly closed.

If there is a power failure or a machine malfunctions, follow the

special procedure for emptying the machine of water (see Clea-

ning the pump , page 16), so that the laundry can be removed.

ON/OFF button not pressed, door not properly closed.

The tap is OFF.

Water level is not reached.

This is not a malfunction! The water inside the machine is below

the level at which it becomes visible.

Degree of soiling was greater than usual.

Change type and amount of detergent.

Select maximum permitted temperature for fabric type.

Select a more powerful washing programme.

Too much detergent or top loading detergent was used. Switch

off the machine for approximately 5-10 minutes. To reduce the

amount of suds, put a tablespoon of fabric softener mixed with

1/2 litre water into the detergent drawer. For the next washing,

adjust the amount of detergent accordingly.

Certain detergents tend to produce more foam but this does not

affect the rinsing result.

This is not a malfunction! It is normal for noises to be heard while

the motor is running in.

This is not a malfunction! It is normal for noises to be heard from

the pump during the start or the final stage of draining the drum.

- Transit bolts were not removed. Follow the directions in the

installation instructions (page 20).

- The machine s feet were not secured in place when the

machine was installed. Realign the machine using a spirit

level, securing the machine s feet according to the installation

instructions.

Pump blocked

This may appears after installing the transport bolts. Remove the

transport bolts, operate the machine for a period of time, the gasket

will return to the original shape.