- ページ 3

IP電話 Cisco 7911G - IP Phone VoIPのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Cisco 7911G - IP Phone VoIP 4 ページ。 Unified ip phone
Cisco 7911G - IP Phone VoIP にも：ユーザーマニュアル (21 ページ), ユーザーマニュアル (25 ページ), クイック・リファレンス (2 ページ), 質問と回答 (5 ページ), 基本マニュアル (5 ページ), ユーザーマニュアル (15 ページ), クイック・スタート・マニュアル (5 ページ)

Using a Headset

To use a headset, disconnect the handset and connect a headset to the Handset port. For information

about purchasing headsets, see

Using Wideband with your Headset

If you connect a headset to the handset port, be sure that the Wideband Handset setting is disabled.

Choose User Preferences > Audio Preferences > Wideband Handset.

If the Wideband Handset setting shows as dimmed, then this setting is not user controllable

Note

and you must contact your system administrator to change this setting.

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings.

Your system administrator can configure AutoAnswer to use the speaker to answer calls. However,

you can only monitor the call using the speaker. To talk to the caller, you must pick up the handset.

Cisco Unified IP Phone 7906G and 7911G User Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP) 3

Headset Support, page

Using a Handset, Headset, and Speaker