- ページ 17
洗濯機 Siemens WU P SeriesのPDF 取扱説明書および取付説明書をオンラインで閲覧またはダウンロードできます。Siemens WU P Series 40 ページ。
Alignment
Level the appliance using a spirit level.
Incorrect levelling may result in intense
noise, vibrations and "wandering".
Loosen the lock nuts using a
1.
wrench, by turning it in a clockwise
direction.
Check the alignment of the
2.
appliance with a spirit level, and
adjust it if necessary. Change the
height by turning the appliance feet.
All four appliance feet must stand
firmly on the ground.
Tighten the lock nut against the
3.
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
Electrical connection
Electrical safety
:
Warning
Risk of electric shock!
Risk of death if live parts are touched.
When disconnecting the main plug,
■
always pull the plug itself and not the
cable, otherwise the cable could be
damaged.
Never touch or hold the mains plug
■
with wet hands.
Never pull out the mains plug during
■
operation.
Only connect the washer dryer to an
■
alternating current using a correctly
installed earthed socket.
Positioning and connecting
The mains voltage must be the same
■
as the voltage specifications on the
washer dryer (appliance rating
plate).
The connected load and the required
■
fuse are also indicated on the
appliance rating plate.
Ensure that:
The mains plug and socket match.
■
The cable cross-section is adequate.
■
The earthing system has been
■
installed correctly.
A damaged power cord is only
■
replaced by an electrician.
A replacement mains cable can be
obtained from customer service.
You do not use multiple plugs/
■
couplings or extension cables.
If a residual-current-operated circuit
■
breaker is used, you use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
The mains plug is always accessible.
■
The power cord is not kinked,
■
crushed, altered or severed and has
not come into contact with any heat
sources.
en
17