- ページ 33
洗濯機 Siemens XQG80-WM10P1681WのPDF 取扱説明書および取付説明書をオンラインで閲覧またはダウンロードできます。Siemens XQG80-WM10P1681W 34 ページ。
ページを印刷するBefore washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean programme the first time
without washing.
The washing machine must have
Note:
been installed and connected properly.
See chapter Installing ~ Page 28
Insert mains plug.
1.
Turn the tap on.
2.
Close the washing machine door.
3.
Do not load any washing.
Select Drum clean 40°C
4.
programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
dispenser II.
Add standard detergent to
7.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
Close the detergent drawer.
8.
Select Start/Reload.
9.
When the programme ends, switch
10.
off the appliance.
Your washing machine is now ready
for use.
Installation and connection
Transportation
Remove covers and keep in a safe
1.
place.
If required, use a screwdriver.
Insert all 4 sleeves.
2.
Clamp mains cable on the holders.
Insert and tighten the bolts.
Before switching on the appliance:
Notes
Always remove the transportation
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the Spin
programme.
en
33