- ページ 5
IP電話 Cisco 7920 - Unified Wireless IP Phone VoIPのPDF はじめにをオンラインで閲覧またはダウンロードできます。Cisco 7920 - Unified Wireless IP Phone VoIP 7 ページ。 Unified wireless ip phone
Cisco 7920 - Unified Wireless IP Phone VoIP にも： クイック・スタート・マニュアル (5 ページ), データシート (6 ページ), 規制遵守と安全情報マニュアル (13 ページ)
ページを印刷する
Do not charge the battery pack if the ambient temperature exceeds 104 degrees
Caution
Fahrenheit (40 degrees Celsius).
Do not expose the battery pack to high storage temperatures (above 140 degrees
Caution
Fahrenheit, 60 degrees Celsius).
When discarding a battery pack, contact your local waste disposal provider regarding
Caution
local restrictions on the disposal or recycling of batteries.
To obtain a replacement battery, contact your local dealer. Use only the batteries that have
Caution
one of the following Cisco part numbers: CP-BATT-7920-STD (standard battery) or
CP-BATT-7920-EXT (extended use battery).
Caution
Use only the power supply that is provided by Cisco. The Cisco part numbers are:
CP-PWR-7920-NA (for North America), CP-PWR-7920-CE (for Central Europe),
CP-PWR-7920-UK (for United Kingdom), CP-PWR-7920-AU (for Australia), and
CP-PWR-7920-JP (for Japan).
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information for the Cisco Unified Wireless IP Phone 7920 document that accompanied this
product.
Installing and Removing the Battery
You must install and charge the battery before you can use the Cisco Unified Wireless IP Phone 7920.
To install or remove the battery, follow these steps.
Step 1
To install the battery, insert the two catches of the battery (as shown in Figure 1) in the
corresponding slots near the bottom of the Cisco Unified Wireless IP Phone 7920. Make sure
that the metal contacts on the battery and the phone are facing each other.
Press the battery to the body of the phone until it locks into place.
Step 2
To remove the battery, press down on the locking catch of the battery. Then lift and remove
Step 3
the battery.
12
78-16631-01